The General Dynamics F-111E is a versatile multi-purpose fighter-bomber in the service of the USAF. Based on the original F-111A, the -E version differs primarily in the use of the revised Triple-Plow II engine inlet. Like the preceding -A model, the -E was designed with the Radar Homing and Warning gear (RHAW) installed. Hard points for additional electronics are located under the wings and fuselage. The total production run for the F-111E amounted to 94 units.

FEATURES -
Plastic pieces attached to sprues and molded in grey.
The surface of the plane is decorated with fully engraved panel lines and rivet detail.
Highly detailed cockpit interior is filled with an accurately modeled seat and controls.
Wings may be assembled in an extended or swept back position.
Arresting hook assembly is included.
The hard-point load outs include an ECM, a bomb dispenser, AIM-9 sidewinder missiles, and extra fuel cells.
Clear plastic canopy allows close inspection of the cockpit.
Detailed pictorial instructions guide you through assembly.

REQUIRES - Cement, hobby knife, tweezers, sprue cutter, file, scissors, cloth, water, paint, brushes, pin vise, glue tips and adult supervision.

Finished model measures 10-1/4 inches long with a 16 inch wingspan.

1/48 Scale

Suitable for ages 10 and up. Adult supervision is recommended.